13
Performing a Wash CycleWash Cyclee
Brief guide
A wash cycle consists of the following steps:
1. Open the door and load the washing.
2. Close the door.
3. Add detergent/additives.
4. Set the appropriate wash programme:
– Set the programme and temperature using the
programme knob
– Set additional programme functions as required.
5. Change the Spin Speed / press RINSE HOLD
(Spülstopp, Arrêt Cuvé Pleine) as necessary.
6. Start the wash programme by pressing the
START/PAUSE (Start/Pause, Marche / Pause)
button.
After the wash programme is complete:
Important! If the wash cycle was stopped with Rinse
Hold, select DRAIN (Pumpen, Vidange) or SPIN
(Schleudern, Essorage) before opening the door.
7. Open the door and take out the washing.
The door can be opened after the DOOR (Tür,
Porte) light goes off and the END (Ende, Fin) light
has come on.
8. Switch off the washing machine: Turn the pro-
gramme knob to OFF (Aus, Arrêt).
To Next Page