15
ENGLISH
BEFORE FIRST USE4.
Ensure that the electrical and water
connections comply with the
installation instructions.
Put 2 litres of water in the detergent
compartment for washing phase. This
activates the drain system.
1.
2.
3.
Select a Cottons cycle at 90 °C,
without any laundry in the machine, to
remove any manufacturing residue
from the drum and tub then start the
machine.
DAILY USE5.
Press the On/Off button to turn on the
washing machine. Touch one of the
Program Icons to choose the wash
program you require.
For correct operation of the load
sensor, activate the appliance and
set a wash program BEFORE
loading the laundry in the drum.
(see page 8)
Check and remove objects (if there
are any) that could be trapped in the
fold.
1.
2.
5.1 Loading The Laundry
Connect the main plug to the main
socket.
Turn the water tap on.
3.
Place the laundry in the drum, one
item at a time, shaking them out as
much as possible. (Refer to page 19
“WASHING HINTS”)
5.
Close the door.
CAUTION
6.
4.
Make sure
that no
laundry
remains
between the
seal and the door.
To restart the program from the point at
which it was interrupted, press this
touchpad again, the Start/Pause pilot
light will stop flashing.
●
Add Clothes ( )
While running a program, you may add
clothes by:
Pressing the “Start/Pause”
touchpad to pause the program.
You can only add clothes if
“Start/Pause” pilot light is lit.
1.
Wait for the machine to come to a
complete stop before opening the
door.
2.
Resume the program by pressing
“Start/Pause” touchpad again.
4.
Add clothing and close the door.
3.
During installation or before first use you
may observe some water in the machine.
This is a residual water left in the
machine after a full functional test in the
factory to ensure the machine is
delivered to customers in perfect working
order and is no cause for concern.
To Next Page
Loading...
