When the washing machine displays the below content with a buzzer, it will
automatically power off after 10 minutes.
Identify the problem and if possible, rectify it before contacting local service. Do
not dismantle and repair the machine without authorization.
Note: In “E8” machine will be self performed load adjustment for twice.
In “E4” after machine had self performed load adjustment twice and unsuccessfully.
TROUBLESHOOTING
14
Machine does not
operate during
delay or spin dry
after washing.
1.Lid is opened when delay start
is selected.
2.Lid is opened during spin cycle.
Close the lid.
E3
Water cannot be
drained
1.Drain hose is placed too high.
2.Drain hose is blocked /bent/
squashed.
1.Lower the drain hose and
press Start/Pause.
2.Check drain hose for blockage
or being bented / squashed
and press Start/Pause to
resume operation.
E5
Program Display Possible causes
What to do
No filling of water 1.Water tap is not turned on.
2.Inlet hose is blocked.
1.Turn on the water tap.
2.Clean tap filter/water inlet filter.
E1
Machine goes
out of balance or
vibrates
excessively
during
spinning
1.Uneven floor.
2.Adjustable feet is not adjusted.
3.Clothes is not evenly adjusted.
1.Adjust the machine level with
the adjustable feet.
2.Redistribute clothes evenly.
E4
Abnormal water
level signal
1.Water inflows too much and
exceeds max water level.
2.The water level is abnormal.
The program adjusts and
recovers automatically.
E2
Machine not
working
Lid is not closed with “Child Lock”
option selected.
Close the lid within 10 seconds
and machine will recover
automatically.
Note:
If the lid is not closed in 10
seconds, machine will drain water
automatically.
E7
If the machine displays any of the code below when it is powered on, this is due
to the memory of machine last status prior to automatic power off.
E8
Need help?
General
Weight and Dimensions
