27
ENGLISH
The washing powder and additive
dispenser drawer should be cleaned
regularly. Remove the drawer by pressing
(PUSH) the catch downwards and by
pulling it out. Flush it out under a tap, to
remove any traces of accumulated powder.
10.5 Cleaning The Dispenser
Drawer
Leave the door open for a while. This
helps to prevent mould and stagnant
smells forming inside the appliance.
Keeping the door open after a wash will
also help to preserve the door seal.
10.3 After Each Wash
To aid cleaning, the top part of the
additive compartment should be removed.
Having removed the drawer, use a small
brush to clean the recess, ensuring that
all washing powder residue is removed
from the upper and lower part of the
recess. Replace the drawer and run the
rinse program without any clothes in the
drum.
10.6 Cleaning The Drawer
Recess
10.7 Cleaning The Pump
The appliance does not drain the water.
The drum cannot turn.
The appliance makes an unusual noise
because of the blockage of the drain
pump.
The display shows an alarm code
because of the problem with water
drain.
Regularly examine the drain pump
and make sure that it is clean.
Clean the pump if:
1. Disconnect the mains plug from the
mains socket.
WARNING!
3
1
2
With the use of low temperature washes
it is possible to get a build up of residues
inside the drum.
We recommend that a maintenance
wash be performed on a regular basis.
10.4 Maintenance Wash
The drum should be empty of laundry.
Select the hottest cotton wash program.
Use a normal measure of detergent,
must be a powder with biological
properties.
To run a maintenance wash:
Press “Start/Pause ” to start the
program.
To Next Page
Loading...
