Electrolux EWW14012 - Emergency Door Opening Procedure

ENGLISH 33
In case of power failure or appliance failure the appliance door remains locked. The washing
programe continues, when the power is restored. If the door remains locked in case of
failure, it is possible to open it using the emergency unlock feature.
Before opening the door:
Emergency Door Opening
Malfunction Possible cause Solution
The electronic unbalance detection
device has cut in because the laundry
is not evenly distributed in the drum.
The laundry is redistributed by reverse
rotation of the drum. This may happen
several times before the unbalance
disappears and normal spinning can
resume. If, after 10 minutes, the
laundry is still not evenly distributed in
the drum, the machine will not spin. In
this case, redistribute the load
manually and select the spin program.
Machine not installed properly. Make sure the levelling of the
appliance is correct. Refer to
“Installation”.
Transit bolts or packaging
not removed.
The load may be too small.
Make sure that the packaging
and/or the transit bolts are
removed. Refer to “Installation”.
Machines based on modern
technology operate very economically
using very little water without affecting
performance.
Add more laundry in the
drum.
Pause the machine and
redistribute laundry
manually.
Spinning starts
late or the
machine does
not spin:
The machine
makes an
unusual noise:
No water is
visible in the
drum:
Make sure that the water temperature and the laundry are not hot. Wait till they
cool down, if necessary.
WARNING!
Make sure that the drum is not rotating. Wait till the drum stops rotating, if
necessary.
Make sure that the water level inside the drum is not too high. Proceed with an
emergency drain, if necessary (refer to “Care and cleaning” chapter).
Machine is optimizing the drying cycle
according to the laundry type and
load size. It will vary for each kind of
fabric as the water absorption is
different.
This is a normal behavior of
the machine and not a cause
for concern as it does not
compromise its performance.
Display time is
frozen at the
end of drying
cycle for more
than 30
minutes: