PART PART NAME QUANTITY
C Window/Exhaust Adaptor B 1 pc
D Window Sliding Kit 1 pc
E
Foam Seal 3 pc
F Remote Control 1 pc
G Battery (for remote control) 2 pc
H
Wall Adaptor (for permanent duct mounting) 1 pc
I Wall Plug 4 pc
J
Screws 4 pc
INSTALLATION
EXHAUSTING HOT AIR
WINDOW DISCHARGE
In the COOLING mode (COOL) the appli-
ance must be placed close to a window so
that the warm exhaust air can be ducted
outside. First, place the unit on a flat floor
and make sure there’s a minimum of 30,5
cm clearance around the unit, and is within
the vicinity of a single circuit outlet power
source.
1. Take the hose out from back of the unit
2. Remove adaptor A from units by sliding
sideways.
3. Extend either side of the hose and
screw the hose to adaptor A.
electrolux 5
To Next Page
Loading...
