Need help?Do you have a question about the Electrolux FMB330RGC0 and is the answer not in the manual?
General| Category | Dishwasher |
|---|---|
| Type | Freestanding |
| Control Type | Electronic |
| Number of programs | 6 |
| Noise level | 49 dB |
| Place settings | 13 |
| Water consumption | 11 L |
| Delay start | Yes |
| Child lock | Yes |
| Dimensions (H x W x D) | 850 x 600 x 625 mm |
Essential safety guidelines to prevent injury and property damage during appliance servicing.
Steps to take before servicing or moving the appliance, including power and supply disconnection.
Mandate to use only cataloged replacement parts to maintain safety standards.
Importance of proper grounding wire color coding and re-establishing safety grounds.
Ensuring all electrical connections, dressing, and panel reassembly are correct before returning.
Explains the electrical timer and provides steps for its testing and operation.
Details the multi-function selector switch and its testing procedure.
Describes the door latch mechanism and testing for door switches.
Overview of the dispenser unit, its operation, and testing methods.
Covers the wash cycle, water fill, and the function of the wash motor.
Describes the drain pump's function and the operation of the water inlet valve.
Explains the lower and center spray arms and the dishwasher's filtering system.
Details the function of control/safety thermostats, heater, and air gap.
Covers the sump reservoir, delivery tube system, and door seal installation.
Information on door hinges, springs, and the replacement of tub rollers.
Explains the location and function of the air vent and vent housing.
Steps for removing the outer door panel and console assembly.
Procedures for servicing the timer, door latch, and selector switch components.
Instructions for removing vent housing, dispenser, and spray arms.
Guide for removing and installing the dishwasher door seal.
Steps for replacing the water valve and servicing thermostats.
Covers replacement of the pressure switch, adjustment of door springs, and hinge assembly removal.
Detailed steps for removing and servicing the wash motor and pump.
Procedure for removing and replacing the dishwasher drain pump.
Instructions for replacing the heater element and the sump assembly.
Details on voltage, frequency, supply water requirements, and flow rate.
Identifies typical leak points and their potential causes.
Addresses issues like poor cleaning, drying, or staining with diagnostic guidance.
A detailed diagram showing timer switching operations across various cycles.
To Next Page