Electrolux FROST- FREE User Manual

29
Clause-Remedy
1. Erratic control thermostat, or setting too cold -
replace are reset to normal position.
2. Freezer exposed to unusual heat - relocate freezer.
3. Abnormally high room temperature - advised
customer.
4. Low pumping capacity compressor - replaced
compressor.
5. Lid gasket not ceiling - adjust or replace necessary
parts.
6. System undercharged - check for leaks.
8. Interior light stays on - check lid switch.
9. Non-condensables in system - replaced filter drier,
evacuate, and recharge.
10. Capillary tube kinked or partially restricted - replace
heat exchanger.
11. Filter drier, partially restricted - replace filter drier.
12. Excessive service load - advise customer.
13. Restricted airflow over condenser - ensure condenser
has unobstructed airflow.
1. Tubing vibrates - adjust tubing.
2. Internal compressor noise - replaced compressor.
3. Compressor vibrating on cabinet frame - just
compressor.
4. Loose parts - check shelving, kick plate, and
defrost drain pan.
5. Compressor operating at high head pressure due to
restricted airflow around freezer - ensure freezer is
installed properly.
Complaint.
Compressor Runs Too Much or 100%.
Noisy.

Electrolux FROST- FREE Specifications

General

Capacity	Varies by model (check specific model)
Defrosting System	Frost Free
Energy Efficiency Class	Varies by model (typically A++ or higher)
Number of Shelves	Varies by model
Noise Level	Varies by model (typically around 40 dB)
Dimensions	Varies by model
Weight	Varies by model
Color	White or Stainless Steel (depending on the model)