Problem Possible cause Remedy
Automatic Heat Up does not op‐
erate.
The highest heat setting is set. The highest heat setting has the same
power as the function.
The zone is hot. Let the zone become sufficiently cool.
There is a dark area on
the multiple zone.
It is normal that there is a dark area
on the multiple zone.
The control panel becomes hot to
the touch.
The cookware is too large or you put
it too close to the control panel.
Put large cookware on the rear zones,
if possible.
There is no sound when you
touch the panel sensor fields.
The sounds are deactivated. Activate the sounds. Refer to "Daily
use".
comes on.
Child Safety Device or Lock oper‐
ates.
Refer to "Daily use".
and a number come on.
There is an error in the hob. Deactivate the hob and activate it
again after 30 seconds. If comes
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
comes on.
The second phase of the power sup‐
ply is missing.
Check if the hob is correctly connected
to the electrical supply. Remove the
fuse, wait one minute, and insert the
fuse again.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
9. TECHNICAL DATA
9.1 Rating plate
Model HOC650F PNC 949 492 648 00
Typ 60 HAD 56 AO 220 - 240 V / 400 V 2N, 50 - 60 Hz
Made in: Romania
Ser.Nr. ................. 7.1 kW
ELECTROLUX
ENGLISH 15
To Next Page
Loading...
