Make sure that you put the glass panels
(A and B) back in the correct sequence.
Check for the symbol / printing on the
side of the glass panel, each of the
glass panels looks different to make the
disassembly and assembly easier.
When installed correctly the door trim
clicks.
Make sure that you install the middle
panel of glass in the seats correctly.
12.7 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Before you replace the lamp:
Step 1 Step 2 Step 3
Turn off the oven. Wait un‐
til the oven is cold.
Disconnect the oven from
the mains.
Put a cloth on the bottom
of the cavity.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table
please contact with an Authorised
Service Centre.
www.electrolux.com38
To Next Page
Loading...
