3.2 Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
3.3 Connection cable
• The hob is supplied with a connection
cable and a safety plug. The connection
cable may only be installed by a qualified
electrician.
• To replace the damaged mains cable, use
the cable: H03V2V2-F or H05BB-F which
withstands a temperature of 90 °C or
higher. Contact an Authorised Service
Centre. The connection cable may only be
replaced by a qualified electrician.
• The appliance works either at 50 Hz or 60
Hz and does not require any additional
action from a qualified electrician in order
to switch between frequencies.
3.4 Connection diagram
Insert the shunt between the screws
as shown. The shunt is located in the
pocket of the mains terminal cover.
Wiring colours
N2 N1 L2 L1
- Blue - Brown
3.5 Assembly
If you install the hob under a hood, please
see the installation instructions of the hood
for the minimum distance between the
appliances.
ENGLISH 7
To Next Page
Loading...
Need help?
General
