Problem Possible cause Remedy
The display shows "F102". • You did not fully close
the door.
• The door lock is defec‐
tive.
• Fully close the door.
• Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows
"F102" again, contact
the Customer Care De‐
partment.
The display shows an error
code that is not in this ta‐
ble.
There is an electrical fault. • Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.
There is water inside the
oven.
There is too much water in
the tank.
Deactivate the oven and
wipe the water with a cloth
or sponge.
The indicator is off.
There is not enough water
in the tank.
Fill the tank with water until
the indicator turns on. If
water starts to leak in the
oven, and the indicator is
still off, contact a qualified
service engineer.
The indicator is on.
There is no water in the
tank.
Fill the tank. If the indicator
is still on, contact a quali‐
fied service engineer.
The steam cooking does
not work.
Lime obstructs the hole. Check the steam inlet
opening. Remove the lime.
The steam cooking does
not work.
There is no water in the
tank.
Fill the water tank.
It takes more than three
minutes to empty the water
tank or the water leaks
from the steam inlet open‐
ing.
There are lime deposits in
the oven.
Clean the water tank. Re‐
fer to "Cleaning the water
tank".
www.electrolux.com40
To Next Page
Loading...
