12 www.electrolux.com
Problem Possible cause Solution
The appliance has no
power. There is no voltage
in the mains socket.
Connect a different electri-
cal appliance to the mains
socket. Contact a qualied
electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the
lamp".
If your appliance is still not working properly after making the above checks, contact the
After Sales Centre.
8.1 Replacing the lamp
This appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
control unit. Contact your Service Center.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
“Installation”.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
9. INSTALLATION
WARNING!
Read the “Safety Information”
carefully for your safety and
correct operation of the
appliance before installing the
appliance.
9.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
9.2 Location
Important! There is a need of good
ventilation around the fridge for easy
dissipation of heat, high efciency of
refrigeration and low power consumption.
For this purpose, sufcient clear space
should be available around the fridge.
It is advisable for there to be 75 mm
separating the back of the fridge to the
wall, at least 100 mm of space at its two
sides,height of over 100 mm from its top
and a clear space upfront to allow the
doors to open 160°.
To Next Page
Loading...
Need help?
General
