Electrolux SB225 - Page 16

16 www.electrolux.com
18. Transfer the upper hinge part and put
the upper hinge axis into the upper
hole of the upper door, and adjust
the position of the upper door (please
support the upper door with your hand
when doing it), xing the upper hinge
part with the special ange self-tapping
screws.
19. Install the screw hole cover on the top
right corner of the refrigerator. Install
the upper hinge cover (which is in the
plastic bag) on the left corner and
screw it in. Put the other upper hinge
cover into the plastic bag.
20. Open the upper door and install the
door shelves, then close it.
WARNING!
When changing the side
at which the door opens,
the appliance must not be
connected to the mains.
Remove plug from the mains
beforehand.
21. Use a acuminate thing to prie the
handle covers and screw hole covers,
unscrew the special self-tapping
screws which are used for xing the
handle, place the handle to the right
side, and install it, and t the screw hole
covers to the other side. Unscrew the
self-tapping screw which is used for
xing the door stop and install the door
stop on the left side.