15 ENGLISH
12. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts, and
remove the front feet xed board and
the lower hinge part by unscrewing the
special ange self-tapping screws.
13. Unscrew the bottom hinge axis and t
it to the hole which is side-by-side and
screw it in.
14. Replace the lower hinge part to the left
side and xing it with the special ange
self-tapping screws. Replace the front
feet xed board to the other side and
xing it with the special ange self-
tapping screws. Install the ajustable
bottom feet parts.
15. Transfer the lower door to the property
position, adjust the lower hinge part,
put the hinge axis into the lower hole of
the lower door, then tighten the bolts.
16. Upturn the middle hinge part the
direction 180 degree, transfer it and
adjust its position. Put the middle hinge
axis into the upper hole of the lower
door, tighten the bolts.
17. Transfer the upper door to the
appropriate position. Secure the door’s
level; put the middle hinge axis into the
lower hole of the upper door.
To Next Page
Loading...
