CHILD LOCK FUNCTION
The child lock can be set to prevent the
children to play with the appliance. The
child lock function locks all push buttons
and the programme dial (this function does
not lock On/Off (Ein/Aus) button). To acti-
vate the child lock function push the Time
Drying (Zeitwahl) and Delay Start (Zeitvor-
wahl) buttons at the same time until the
symbol
come into view on the display.
To deactivate push again the above buttons
until the symbol go out of view.
You can activate the child lock function:
• before you push the Start/Pause button -
the appliance cannot start
• after you push the Start/Pause button -
all the push buttons and the programme
dial are deactivated
AT THE END OF PROGRAMME
When the drying cycle is completed, the
symbol flashes on the display. If the Buzzer
(Signal) function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
1. Push the On/Off (Ein/Aus) button for 2
seconds to deactivate the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Important! After each drying cycle:
• clean the filter
• drain the water container
(See chapter CARE AND CLEANING.)
HINTS AND TIPS
ECOLOGICAL HINTS
•Do not use fabric softener to wash and
then dry. In the tumble dryer laundry be-
comes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with a
coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the bot-
tom of the appliance clear.
• Use the load volumes which are specified
in the programmes chapter.
• Make sure that is good airflow in the ap-
pliance installation position.
• Clean the primary filter after each drying
cycle.
• Clean the heat exchanger filters when the
applicable indicator comes into the view
on the control panel.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe 1200 g
quilt cover 700 g
man’s work shirt 600 g
man’s pyjamas 500 g
sheet 500 g
tablecloth 250 g
man’s shirt 200 g
night dress 200 g
pillow case 200 g
towelling towel 200 g
blouse 100 g
ladies’ briefs 100 g
men’s underpants 100 g
napkin 100 g
tea cloth 100 g
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ-
ent locations. Water hardness has an effect
on the water conductivity and the operation
of the conductivity sensor in the appliance.
If you know the value of the water conduc-
tivity you can adjust the sensor to dry with
the better results.
To change the sensor conductivity:
1. Turn the programme dial to available
programme.
32 electrolux
To Next Page
Loading...
