Problem Possible cause/Solution
The machine vibrates or is noisy:
The transit bolts and packing have not been re-
moved.
• Check the correct installation of the appliance.
The support feet have not been adjusted
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
Spinning starts late or the machine does not
spin:
The electronic unbalance detection device has
cut in because the laundry is not evenly distrib-
uted in the drum. The laundry is redistributed by
reverse rotation of the drum. This may happen
several times before the unbalance disappears
and normal spinning can resume. If, after some
minutes, the laundry is still not evenly distributed
in the drum, the machine will not spin.
• The laundry load is perhaps to little, add more
items, redistribute the load manually and then
select the spinning programme.
No water is visible in the drum:
Machines based on modern technology operate
very economically using very little water without
affecting performance.
The display shows the message « Anti-flood-
ing system has been activated. Please
check inlet/drain pipe connections » :
Anti-flooding system has been activated.
• Disconnect the appliance, close the water tap
and contact the Service Force Centre
The drum light doesn’t work:
Please contact your local Service Centre.
If you are unable to identify or solve the prob-
lem, contact our service centre. Before tele-
phoning, make a note of the model, serial
number and purchase date of your ma-
chine: the Service Centre will require this in-
formation.
TECHNICAL DATA
Dimensions Width
Height
Depth
Depth (Overall dimensions)
60 cm
85 cm
60 cm
63 cm
Electrical connection
Voltage - Overall power - Fuse
Information on the electrical connection is given on the rating
plate, on the inner edge of the appliance door.
Water supply pressure Minimum
Maximum
0,05 MPa
0,8 MPa
54 electrolux
To Next Page
Loading...
Need help?
General
