UNBOXING & SETUP – picture pages 6-7
Please be careful while unboxing the air purifier. The unit has several detachable
components which may have come loose in transport, so open the box with care and
while placed on a large flat surface OR the floor.
1. Gently remove the unit (e.g. with top handle when available) and the ancillary
components from the main box. Remove the plas�c packaging and discard as per
safety and local recycling instruc�ons.
2. If wall moun�ng:
a. Please review safety instruc�ons under the GENERAL SAFETY sec�on
before proceeding.
b. Iden�fy a spot on the wall where you would like to mount the unit. The
spot should be at least 20 cm below eye level when standing ful
ly up
right
(even lower is ideal & recommended), for op�mal viewing as well as
cleanability under the unit. Also ensure that nearest power socket is max
1,5 mts away and that there is a clearing of at least 20 cm between right
side (sensor window) of the unit and other nearby surface.
c. Gently place the provided hook flat against the surface of the wall and
with a pencil mark the two spots where screws are to be drilled. The hook
26 27
28 29
To Next Page
Loading...
Need help?
General
