To Next PageTo Next Page
Need help?Do you have a question about the Electrolux Oxygen EAP150 and is the answer not in the manual?
General| Type | Air Cleaner |
|---|---|
| Model | EAP150 |
| Filter Type | HEPA |
| CADR | 150 m³/h |
| Coverage Area | Up to 18 m² |
| Noise Level | 30-60 dB |
| Dimensions | 320 x 320 x 600 mm |
| Weight | 5.2 kg |
| Filtration Stages | 3 |
| Activated Carbon Filter | Yes |
| Ionizer | No |
Lists front panel, carbon pre-filter, HEPA 13 filter, main body, air outlet, and control panel for EAP150.
Lists front panel, filter frame, carbon pre-filter, HEPA 13 filter, and main body for EAP300.
Lists front panel, filter cassette, main body, PlasmaWave fan, air outlet, and control panel for EAP450.
Highlights quiet operation and air quality sensor for the EAP150 model.
Details quiet operation, air quality sensor, light sensor, and automatic air cleaning for EAP300/EAP450.
Explains the 4-stage filtration system of the EAP300, including pre-filter, HEPA, and PlasmaWave.
Describes the 5-stage filtration system of the EAP450, including washable filters and PlasmaWave.
Details the functions of the air quality sensor, reset, check filter, and fan speed indicators/selectors for EAP150.
Explains controls like air quality sensor, reset, check filter, auto mode, PlasmaWave, and light sensor for EAP300/EAP450.
Provides general placement and initial panel removal instructions applicable to all models.
Step-by-step guide for assembling filters and replacing the front panel for the EAP150.
Instructions for installing filters and the internal frame, then replacing the front panel for the EAP300.
Guide to installing the filter cassette and replacing the front panel for the EAP450.
Steps for plugging in, powering on the unit, and sensor calibration after setup.
Instructions for replacing Carbon Pre-Filter and HEPA 13 filter, including replacement intervals.
Details replacing Carbon Pre-Filter and HEPA 13 filter for EAP300, including service life and cleaning.
Guide to replacing the entire filter cassette for EAP450, including service life and cleaning cycles.
Explains how to use the remote control for EAP300/EAP450, including range and mounting.
Describes the functions of the POWER, AUTO, FAN SPEED, and TURBO buttons on the remote.
Instructions for replacing the battery in the remote control, including battery type.
Advice on cleaning the unit with dry/damp cloths and avoiding harsh chemicals.
Guidance on lightly vacuuming the air quality sensor every three months.
Answers regarding washing and vacuuming filters for different models.
Explains initial odours and addresses performance expectations for room size.
Troubleshooting when the air quality light indicates a problem despite clean air.
Addresses fan motor noise, unit producing odors, or not removing them effectively.
Procedure to reset the 'Check Filter' indicator after filter replacement.
