■ ■ ■
EAP300, EAP450
Operate the remote control facing the air cleaner.
Operate within 6 metres of the air cleaner.
The remote control has a separate wall-mountable storage
cradle that can be conveniently attached to any wall using
a screw.
S. POWER: Use the power button to turn the power on and
T. AUTO Mode: Use the AUTO button to put air cleaner in
AUTO mode.
U. FAN SPEED: By pressing up or down, the unit will
change fan speeds and enter into manual mode.
V. TURBO: Use this button to switch from automatic
operation and start the maximum amount of room
air cleaning and air movement. It will remain in Turbo
speed until changed into Auto or manual mode.
Battery replacement
1.
cover out of remote.
2. Insert battery as shown and close battery cover.
3. Always use 3V lithium battery CR2025. Incorrect battery
CARE AND MAINTENANCE
■ ■ ■
EAP150, EAP300, EAP450
CAUTION: Turn o the unit and unplug the electrical cord
before performing any maintenance.
for stubborn stains, use a warm, damp cloth.
or scouring powder, as they may damage the surface.
Keep the unit dry.
■ ■ ■
EAP150, EAP300, EAP450
Occurrence Possible causes/solution
There is an odour coming from the unit and
I just opened it.
The unit has been concealed in a tightly wrapped package of currogated cardboard
week depending on how much it is used.
Will this clean a bigger area than what it is
CADR ratings are provided from a controlled testing environment, if that environment
what the CADR rating is, it will still help improve the air, but may take a bit longer to
do so.
Allow proper air circulation around the sides and infront of the unit. If there are doors
circulate near the machine.
The AIR QUALITY light is orange or red, but
the air seems clean.
Clear the sensor with a vacuum cleaner, as it may be blocked or clogged.
Sometimes a compressed can of air may unclog the dust in the sensor.
There is still some dust you can see in the air
or on my furniture
The unit will capture most dust and particles, however with opening doors, windows,
central HVAC etc… there may still be some level of dust that you can see.
I can hear revving of the fan motor This is normal, especially at night when all environmental sounds are quiet, you may
hear the motor running in repetition.
The unit has stopped removing odours
odour.
Make sure the air quality sensor is not blocked or clogged.
The CHECK FILTER indicator remains lit after
replacing the HEPA lter.
Press the RESET FILTER button by gently inserting a paper-clip into the
RESET FILTER button hole. Hold for 3-5 seconds until a “beep” sounds to
indicate the unit has been reset.
To Next Page
Loading...
