Electron Dynamics TC M series

To Next Page

To Previous Page

TC M Temperature Controller User Manual V1.08

Electron Dynamics Ltd page

7.2.9 Power Up State ...................................................................................................10

7.3 Set point........................................................................................................................10

7.3.1 Method.................................................................................................................10

7.3.2 Pot Range............................................................................................................11

7.3.3 Pot Offset.............................................................................................................11

7.3.4 PC Set Point........................................................................................................11

7.3.5 Control .................................................................................................................11

7.3.6 Output..................................................................................................................11

7.4 Sensor ..........................................................................................................................11

7.4.1 Type.....................................................................................................................11

7.4.2 X2, X, C Coefficients...........................................................................................11

7.4.3 NTC thermistors ..................................................................................................12

7.4.4 Units.....................................................................................................................12

7.5 Output ...........................................................................................................................12

7.5.1 Polarity.................................................................................................................12

7.5.2 Minimum ..............................................................................................................12

7.5.3 Maximum.............................................................................................................12

7.5.4 Frequency............................................................................................................12

7.6 Alarms...........................................................................................................................12

7.6.1 Minimum Alarm ...................................................................................................12

7.6.2 Maximum Alarm ..................................................................................................12

7.6.3 Minimum OK Temperature .................................................................................12

7.6.4 Maximum Temperature.......................................................................................12

7.6.5 Operational temperature max (Only available on certain GUI).........................12

7.6.6 Maximum Temperature (Only available on certain GUI)...............................12

7.7 Report ...........................................................................................................................13

7.7.1 Set point ..............................................................................................................13

7.7.2 Temperature........................................................................................................13

7.7.3 Control .................................................................................................................13

7.7.4 Output..................................................................................................................13

7.7.5 Alarms..................................................................................................................13

7.7.6 Faults ...................................................................................................................13

7.7.7 Temperature OK .................................................................................................13

7.8 Reading and Setting Parameters ................................................................................13

7.8.1 Read Button ........................................................................................................13

7.8.2 Write Button.........................................................................................................13

7.9 Figure TC M series Temperature Controller GUI (Java)............................................14

7.10 C++ GUI........................................................................................................................14

7.10.1 Additional features ..............................................................................................14

7.10.2 Data Logging.......................................................................................................15

7.10.3 C++ GUI ..............................................................................................................15

8 Communication Protocol.......................................................................................................15

9 Specification TC M Series ...............................................................................................16

9.1 Supply...........................................................................................................................16

9.2 Output ...........................................................................................................................16

9.3 Control ..........................................................................................................................16

9.4 Set point........................................................................................................................16

9.5 Alarm.............................................................................................................................16

9.6 Sensor ..........................................................................................................................16

9.7 Measurement Accuraccy .............................................................................................16

9.8 User ..............................................................................................................................16

9.9 Format ..........................................................................................................................16

Main Page

Electron Dynamics TC M series - Page 3

Table of Contents