Electronics International UBG-16 User Manual

Ultimate Bar Graph Engine AnalyzerUltimate Bar Graph Engine Analyzer
Ultimate Bar Graph Engine AnalyzerUltimate Bar Graph Engine Analyzer
Ultimate Bar Graph Engine Analyzer
(UBG-16)(UBG-16)
(UBG-16)(UBG-16)
(UBG-16)
Operating InstructionsOperating Instructions
Operating InstructionsOperating Instructions
Operating Instructions
OI 0505991
You must read this manual before installing or operating the instrument. This
manual contains warranty and other information that may affect your decision
to install this product and/or the safety of your aircraft.
Electronics International Inc. Electronics International Inc.
Electronics International Inc. Electronics International Inc.
Electronics International Inc.
®®
®®
®
5/5/99
Rev. B: 3/10/00
63296 Powell Butte Hwy • Bend, OR 97701 • (541) 318-6060 • Buy-EI.com63296 Powell Butte Hwy • Bend, OR 97701 • (541) 318-6060 • Buy-EI.com
63296 Powell Butte Hwy • Bend, OR 97701 • (541) 318-6060 • Buy-EI.com63296 Powell Butte Hwy • Bend, OR 97701 • (541) 318-6060 • Buy-EI.com
63296 Powell Butte Hwy • Bend, OR 97701 • (541) 318-6060 • Buy-EI.com

Electronics International UBG-16 Specifications

Power

voltage range	7.5 to 30 Volts
current	1/2 Amp.
display	Plasma (viewable in direct sunlight)

Performance

accuracy	1/2%
egt bar resolution	1 to 104°F per Bar
cht bar resolution	33°F per Bar

Channels and Probes

maximum channels	16
egt and cht analyzer channels	1 to 7, programmable
scan rate	1 to 9 second per channel

Weight and Dimensions

weight unit only	22 oz.
weight one probe and 6 foot cable	3.5 oz.
weight one probe and 20 foot cable	7 oz.

Summary

Important Notice and Warranty

Important Notice

Critical information affecting aircraft safety and operation.

Warranty / Agreement

Terms and conditions of the product warranty.

Introduction and Operating Modes

Mode Selector Switch

Normalized Operating Mode

Lean Operating Mode

Procedure for leaning the engine for optimal performance.

Engine Leaning and Peak Detection

Handling False Peaks

Leaning Techniques

Methods for leaning, including rich/lean side procedures.

Alarms and Limit Configuration

Alarm System Overview

Programming EGT/CHT Limits

Setting high/low limits for EGT and CHT.

Programming Other Limits

System Setup and Aircraft Operation

Power-up Programming

Initial configuration of probes and channels for the UBG.

Configuring Input Channels

Setting up EGT/CHT channels and the 7th column.

Operating the UBG in Your Aircraft