Why will my Electronics Line 3208GLD not arm?
If your Electronics Line Security System won't arm, it could be due to an open zone or an invalid user code. Make sure to secure any open zones, or bypass the zone, and use a valid user code.
Why is my Electronics Line 3208GLD keypad beeping?
Your Electronics Line Security System keypad might be beeping because the Entry/Exit delay is active, AC contact has been lost, or the battery is low. The keypad will stop beeping at the end of the Exit/Entry delay. You can also press any key and contact your installer.
What to do if the power light is off on my Electronics Line 3208GLD?
If the power light on your Electronics Line Security System is off, it means AC contact has been lost and the battery is low. Contact your installer.
General| Brand | Electronics Line |
|---|---|
| Model | 3208GLD |
| Category | Security System |
| Language | English |
Overview of system components and initial setup advice.
Explains the LED keypad for system status, zones, programming, and arming functions.
Explains the LCD keypad for system status, zones, programming, and menu navigation.
Details how to navigate and select functions using the LCD keypad menu.
Interpreting various system status messages, including power and communication failures.
Understanding zone status indicators for open, bypassed, or alarmed zones.
Details how alarms are shown on keypads and immediate actions upon returning to an alarmed premise.
Provides guidance on managing accidental alarm activations and notifying authorities.
Explains how the system can be divided into multiple sub-systems.
Instructions for configuring the system's current time and date using keypad commands.
Explains the 'Late to Close' function, activated when remaining on premises beyond the programmed closing window.
Describes the 'Latch Key' feature for verifying user departures or arrivals from protected areas.
To Next Page
