www.electronline.cl
T: 02-23023149
15
6.24.8. Over speed alarm
Set up: Send SMS “speed+password+space+080” to the unit (suppose the speed is 80km/h), and
it will reply “speed OK!”. When the target moves exceeding 80km/h, the unit will send SMS
“speed+080!+ latitude & longitude” to the authorized numbers at interval of 3 minutes.
Cancel: Send SMS “nospeed+password” to deactivate the overspeed alarm.
Note: The recommended speed should be not less than 30km/h. For below that rate, it will be
effected the accuracy by GPS signals drift etc.
6.25. Set up arm/disarm by SMS
Arm
Send SMS command “arm+password” to the tracker device in the vehicle. It will reply “Tracker
is activated” and enter into armed state .
Disarm
Send SMS command "disarm + password" to the tracker device in the vehicle, it will reply
“Tracker is deactivated” in both armed and disarmed state and enter into disarmed state .
6.26. Alarms under Arm State
6.26.1. Shock sensor alarm
Shock sensor alarm is activated automatically with “ARM” command. The unit will send SMS
“Sensor alarm+lat/long” to the authorized number when the sensor is triggered in arm status;
send “disarm+password” to stop it.
Shock sensor sensitivity configuration:
First level: Alarm will be triggered after detect slight vibration, send command"
sensitivity+password+space+1" .
Second level: Alarm will be triggered after detect 8 times vibration in 2 seconds, send command"
sensitivity+password+space+2".
Third level: Alarm will be triggered after detect 25 times vibration in 5 seconds, send command"
sensitivity+password+space+3".
6.26.2. ACC alarm
The unit will send SMS “ACC alarm+lat/long” to the authorized number in at interval of 3
minutes when the engine of the car is turned on, that is the key is rotated to ACC.ON position to
start the car in arm state; send “disarm+password” to stop it.
To Next Page
Loading...