Element EATW2537CW - Understanding the Error Codes; Specifications

Understanding the error codes
Your washer is equipped with an automatic
error-monitoring system to detect and diagnose
problems at an early stage.
ERROR
CODE
POSSIBLE CAUSE SOLUTIONS
Your washer takes
more than 30
minutes to fill with
water.After water
finishes entering
your washer, the
water level has not
changed in five
minutes.
• Make sure that the lid
is not open.
• Make sure that water
is not leaking. See No
water or not enough
water on page 26
on page27
.
The unit takes more
than 10 minutes to
drain.
• See Washer does not
drain or spin
The lid is open.
The washer is not
level.
• Close the lid.
• Level the washer. See
“Step 4: Level your
washer” on page 19.
The EEPROM failed.
Load sensing failed.
Water level sensor
failed.
Lid lock failed.
ERROR
CODE
POSSIBLE CAUSE SOLUTIONS
Your washer is out of
balance more than
three times in spin
operation.
• See Washer vibrates
or is too noisy on
page27 .
Impact switch was
• Adjust the washer
level refer to installation.
• If the situation continues,
call service center.
• Call service
• Call service
center.
• Call service
center.
center.
• Call service
center.
• Call service
center.
• Call service
center.
The PCB failed.
• Call service
center.
Specifications
USER MAINTENANCE INSTRUCTIONS
pressed by the outer
tub cover.
Impact switch was
not be connected.
42.2 in.x 25.2 in. x 27 in.
(107 cm x 64 cm x 68.4 cm)
112.44lbs (51kg)
TYPE
Dimensions
(H x W x D)
Weight
Power
Current draw
Pulsator type
Drum grain
Display type
Display color
Motor
120V~/60Hz
8A
Agitator
Cubic
LED
White
󾾝Single phase induction motor
EATW2537CW
Notice：
1.LED Display：
1)When error happening, Extra Rinse LED will flash and Process LED indicates error code.
2)○-off,◎-flash,●-on
2.When error is happening, the buzzer will beep 5 seconds and repeat once per 15 minutes. After 24 hours, machine will
power off automatically.