For subscribers to Basic Cable TV Service
For basic cable service not requiring a Converter/Descrambler box, connect the CATV 75 ohm Coaxial Cable
directly into the Antenna lack on the back of the television.
[:or subscribers to Scrambled Cable TV Service
If you subscribe to a cable service which requires the use of a Converter/Descrambmer box, connect the incoming
cable to the Converter/Descrambler box and connect the output of the box to the Antenna Jack on the back of
the temevision. Fommowthe connections as shown below. Set the temev[s[onto the output of the
Converter/Descrambmer box (usuammychanne[ 3 or 4) and use the Converter/Descrambmer box to semectchannems.
[:or Subscribers to Unscrambled Basic Cable with Scrambled Premium Channels
][fyou subscribe to a cable service in which basic cable channels are unscrambled and premium channels require
the use of a Converter/Descrambled box, you may wish to use a two-set signal splitter (sometimes referred to
as a two-set coupler) and an A/B Switch box from the cable installer or an electronics supply store. Follow the
connections shown below. With the switch in the B position, you can directly tune any unscrambled channels on
your TV. With the switch in the A position, tune your TV to the output of the Converter/Descrambler box (usually
channel 3 or 4) and use the box to tune scrambled channels.
-- __ Splitter AiBSwitch L_
Note:
When you use a converter box with your TV, there may be features that you cannot
program when using the remote control.
11