Need help?Do you have a question about the Elenco Electronics MO-1251 and is the answer not in the manual?
General| Category | Test Equipment |
|---|---|
| Model | MO-1251 |
| Manufacturer | Elenco Electronics |
| Display Type | Analog |
| Trigger Modes | Auto |
| Display | Analog |
| Type | Analog Oscilloscope |
Detailed identification and function of front and rear panel controls and connectors.
Step-by-step guide for initial setup and powering on the oscilloscope.
Explanation of sweep triggering controls and their functions for stable waveforms.
Procedure for measuring DC and AC voltages using the oscilloscope as a voltmeter.
Measuring AC voltage and frequency using the oscilloscope.
Procedure for accurately measuring DC voltage with the oscilloscope.
Measuring frequency by displaying Lissajous figures in X-Y mode.
Testing electronic components using the oscilloscope's built-in component tester.
Detailed description of the vertical amplifier section, including attenuators and gain stages.
Explanation of the horizontal and time base generation circuits and sweep control.
Procedures for adjusting the voltage outputs of the power supply unit.
Adjustments for the vertical amplifier, attenuators, and DC balance.
Adjustments for the horizontal/time base circuits, sweep linearity, and triggering.
To Next Page
