32
Safety
2.5 Safety information on the technical condition
R The device must be checked for damage and correct operation before ins-
tallation.
R The operator is obligated to operate the device only when it is in perfect
working order and is safe to operate. The technical condition must comply
with the legal requirements at all times.
R Ifdangerstopersonnelorchangesinoperatingbehaviourareidentied,the
device must be shut down immediately and the incident reported to superi-
ors or the operator.
R The device may only be connected to the energy supply intended and desi-
gned for this purpose. Please refer to the type plate or sales documentation
for the permissible voltage type and operating voltage.
R Modicationsandattachmentstoorconversionsofthedevicearenotper-
mitted without the authorisation of the manufacturer.
2.6 Safety information on transport, assembly and installation
The respective transport company is responsible for transporting the device.
The following safety requirements must be observed during transport, assembly
and installation of the device:
R During transport, the device must be secured in accordance with the regula-
tions of the mode of transport used.
R Fortransport,allhoistsandslingsusedmustbesufcientlydimensionedto
safely bear the forces generated during loading, unloading and installation
of the device.
R Only the points indicated on the pallet and the device may be used as slin-
ging and lifting points.
R If work is required on lifted parts or work equipment, these must be secured
against falling using suitable means. Work equipment for lifting loads must
prevent the loads from shifting unintentionally, falling freely or unhooking
unintentionally.
R Standing under suspended loads is strictly prohibited.
R A hard hat must be worn during loading work with hoists.
R Assembly and installation work must only be carried out by trained and
qualiedpersonnel.
To Next Page
Loading...
Need help?
General
