ELEVATE CS RACK SYSTEMS - Install Upright Assemblies Onto T-Slot Compatible Rails; Position and Hand Tighten Upright Assemblies

Install upright assemblies (A) onto t-slot compatible rails.
Remove t-slot compatible rail end plug. Slide two T-bolts
(G) into each adapter rail. Space the T-bolts (G) so they
align with the holes on the base on the upright assembly
(A). Place support base insert (J or K) in between the
upright assembly and the rail. Use T-bolts (H) if installing
on a ush mount rail.
Reinstall the rail end plugs. Install washers (E) and cap nuts
(F) for the upright assemblies (A). Finger tighten for now.
1
2
Screw heads
should be to
the outside of
the bed.
End plugs may vary
depending on t-slot
rail manufacturer.
2209 Kellen Gross Dr., Yankton SD 57078 • 877-878-9336
After installation is complete, upright assemblies (A) in the correct position will lean slightly to the inside of the truck bed.
However, at this time they should move freely. Position upright assembly in the desired location and hand tighten the
washers (E) and cap nuts (F). Space front and rear upright assemblies as far apart as possible to support the load.
3
Screw heads
should be to
the outside of
the bed.
Nuts should be
to the inside of
the bed.
Uprights lean
approximately
2º inward as
shown.
P/N 1118569 Rev. A Rev. 1-7-22
E
F
A
G
G
J
A