Elgato RING LIGHT - Pair Ring Light - Android

2. Once connected to
the Ring Light, scan the
QR code below or enter
http://192.168.62.1:9123/
in the web browser.
If the page does not
come up, mobile network
needs to be disabled in
the Android control
center.
3. The Ring Light
information page will
open. Enter the network
name (SSID), password
and encryption type of
the Wi-Fi network,
then hit connect.
4. Ring Light will turn
off and on again if the
connection is successful.
If Ring Light does not
appear in Control Panel,
and appears in the Wi-Fi
settings of the Android
device, the Ring Light
was not able to pair
successfully. Repeat the
process again and
double check the spelling
of the Wi-Fi SSID and
password.
1. Open the Wi-Fi settings
on the device and
connect to the Ring
Light. Turn on Ring Light.
PAIR RING LIGHT - ANDROID