Eliminator Lighting MEGA FLAT HEX PAK - System Menu Utilities; Dimmer Curve Settings

To Next Page

To Previous Page

SYSTEM MENU

Dimmer Curve Setting:

1. Plug the xture in and press the MODE button until “d.XXX” is displayed, then press the SET UP

button until “dr-X” is displayed. “X” represents a number between 0-4.

2. There are 5 dimmer curve settings to choose from. Please see the Dimmer Curve Chart section of

this manual for the settings and their respective beginning and ending fade times.

Default Running Mode: This returns all modes to their default settings.

1. Plug the xture in and press the MODE button until “dXX” is displayed. “XX” represents either “on”

or “oFF”.

2. Press the SET UP button until “dEFA” is displayed.

3. Press the UP and DOWN buttons simultaneously. Press the MODE button to exit.