7
model no. 011-2002-8 | contact us 1-877-619-6321
• DO NOT allow the positive
and negative clamps of the
boosting cable to touch each
other or another common metal
conductor. Doing so may cause
sparks and/ or damage the
equipment. Always store the
clamps in appropriate holder
on each side of the power pack
after each use.
• Make sure the positive clamp of
the boosting cable is connected
to the positive terminal of the
battery and the negative clamp
is connected to the negative
terminal of the battery. A
reversed polarity connection
(positive to negative) may
cause sparks or damage the
equipment.
• DO NOT use the boosting
feature for more than 5
seconds, as it is designed for
short term operations only.
Doing so may damage the
equipment. Allow the power
pack to cool for at least
3 minutes after each boosting
operation.
SAFETY PRECAUTIONS
WHEN WORKING WITH
BATTERIES
Follow all instructions mentioned
by the manufacturer to avoid
explosion of the battery.
SHOCK AND FIRE HAZARD
• DO NOT work near lead-acid
batteries, as the batteries
generate explosive gases during
normal operation.
• DO NOT drop a metal tool on
the battery, as doing so can
create spark or short circuit in
the battery or other electrical
parts, resulting in battery
explosion.
• While removing the battery,
make sure to remove grounded
terminal from the battery and
disconnect other electrical
connections.
• Always have assistance nearby
when working with the lead-
acid batteries.
• DO NOT use this device
to charge nickel cadmium
batteries.
SAFETY INFORMATION
To Next Page
