Elite Screens AEON series - Detailed Edge Trim Installation; Applying and Securing Trim Strips; Corner Sleeve Installation

Rev.04/17/2017 DR www.elitescreens.com 11
2. Without removing the adhesive tape, place all the trim pieces along the edge of screen material. Adjust the trim so
that the top and bottom trim pieces are touching and show no gaps in the center. (Note: The Elite logo should be
positioned on the bottom right). Refer to Figure 2 below for a visual reference.
NOTE: Make sure the bottom edge trim with the Elite Screens logo is installed on the correct side. The back of the
material should be labeled with a DOWN sticker to indicate the material is facing in the down position. The Elite
Screens logo should be installed on the DOWN side
3. After properly aligning all trim pieces, carefully remove trim piece A (see Figure 3 below). Remove the inside
backing of the tape and place the trim piece in its original position on the frame. Repeat this step for the remaining
trim pieces in the following order: B-C-D-E-F.
4. After the bezel trim has been installed, place a corner sleeve (N) on all four corners. Begin by aligning and
adjusting the corner sleeve through the front of the screen. Make sure the corner sleeve completely wraps the edge
of the bezel trim. This should cover any corner gaps.
Once all corner sleeves have been snapped into each corner of the frame, it is ready to be installed.
Front side
Trim
strip
Front Side
Back Side
A
B
F
C
D
E
Back side
Figure 2
Figure 3
The front side of the frame with trim pieces attached.
TIP:
Align the trim starting
from the center to reduce
gapping. Any gaps left at
the corners will be
covered by the corner
sleeves.
Corner gap
will be
covered by
the corner
sleeve (N).
White area
signifies
corner gap.
White area
signifies
corner gap.