Detecting method
Halogen leak detector operation method:
When the detector is turned on or Off by pressing ON/OFF key, all LED
indicator lights are on for three seconds, and the detector will automatically
reset. After auto-reset, only the first LED indicator light on the left will be on
(Green, batteries fine, orange, batteries getting weak, replace as soon as
possible; red indicates the batteries need to be replaced before normal
detecting). At this time the beeping sounds regularly and the detector sets the
atmosphere halogen evel to "zero", ready for detection.
Operation Instruction:
1 Check the battery level by observing the power indicator light.
2 Once tum on the detector, the default sensitivity level is level 5 You wil hear
rapid, but steady beep sound. The sensitivity can be adjusted by pressing
SENS , according to your requirement
3 Begin searching for eaks. When refrigerant is detected, a siren will be
sounded, with a rate quite different from previous beep sound And the
indicator lights will progressively turn on.
4 Sensitivity can be adjusted at any time during operation by pressing SENS
key. This adjustment will not interrupt detection
5 If alarm occurs before the sensing tip touches with the leakage source,
press RESET key to reset the current to O until there is no alarm, then
you could detect again
Halogen leak detector detecting method:
See Figure 4
5
To Next Page
Loading...
