To Next PageTo Next Page
Need help?Do you have a question about the Elkay LZS8WS 1F Series and is the answer not in the manual?
General| Category | Water Dispenser |
|---|---|
| Type | Bottle Filling Station & Water Cooler |
| Material | Stainless Steel |
| Beverage Type | Water |
| Voltage | 115V |
| Hertz | 60 Hz |
| Model | LZS8WS |
| Installation Type | Wall Mount |
| Weight | 64 lbs |
| Mounting Style | Wall Mount |
| Bubbler Activation | Sensor |
| Bottle Filling Station Activation | Sensor |
| Refrigerant Type | R134a |
| Finish | Stainless Steel |
| Power | 115V |
| Heating Capacity | Not Applicable |
| Dimensions | 18-1/8" (460mm) x 18-5/8" (473mm) x 39-1/16" (992mm) |
Connect water inlet and install the trap assembly securely.
Adjust stream height using the screw for optimal basin impact.
Steps for removing and installing the bubbler assembly.
Connect water line, install filter cartridge, and check for leaks.
Reset the visual filter monitor to indicate a new filter.
Reset the bottle counter and test its functionality.
Wiring schematic for 115V non-refrigerated units.
Wiring schematic for 115V refrigerated units.
Wiring schematic for 230V refrigerated units.
