To Next PageTo Next PageWhat to do if water flow is not regulated in Elkay SWIRLFLO LZWS-LRPBM28K Plumbing Product?
If the orifice is clean, regulate the flow as described in Step 14 of the installation instructions. Should a replacement be necessary, consult the parts list to find the correct regulator part number.
How to remove tubing from lead-free connectors in Elkay SWIRLFLO LZWS-LRPBM28K Plumbing Product?
Elkay coolers are equipped with lead-free connectors using an o-ring water seal. To remove tubing, first relieve water pressure. Then, push in on the gray collar while simultaneously pulling on the tubing. To insert tubing, push the tube straight into the fitting until it reaches a positive stop, which is approximately 3/4 of an inch.
How to remove mineral deposits from Elkay SWIRLFLO LZWS-LRPBM28K Plumbing Product orifice?
Mineral deposits causing water flow issues in your Elkay Plumbing Product can be removed from the orifice. Gently poke at the deposits with a small, round file no larger than 1/8” in diameter, or use a small diameter wire.
General| Brand | Elkay |
|---|---|
| Model | LZWS-LRPBM28K |
| Category | Plumbing Product |
| Installation Type | Wall Mounted |
| Material | Stainless Steel |
| Finish | Light Gray Granite |
| ADA Compliant | Yes |
| Filtered | Yes |
| Bubbler Material | Stainless Steel |
| Cabinet Finish | Light Gray Granite |
| Installation Location | Indoor |
| Number of Stations | 1 |
| Power | 115V/60Hz |
| Visual Filter Monitor | Yes |
| Mounting Type | Wall Mount |
| Water Connection | 3/8" O.D. Tubing |
| Flow Rate | 1.1 GPM |
| Bottle Filling Sensor | Yes |
| Faucet Sensor | Yes |
| LEED Compliant | Yes |
| Type | Bottle Filling Station |
| Cooling Capacity | 8 GPH |
| Activation Method | Sensor |
| Mounting Option | Wall Mount |
| Operation | Sensor |
| Options | Filtered |
| Rated Watts | 370 |
| Product Type | Bottle Filling Station |
Verify the control board software designation upon unit startup.
Configure filter monitoring, bottle count reset, and filter capacity settings.
Adjust IR sensor range and set the unit type (refrigerated or non-refrigerated).
Address mineral deposits on orifice that cause water flow to spurt or not regulate.
Adjust flow regulation for the bubbler stream height as per installation instructions.
Learn how to attach and detach tubing from lead-free quick connect water fittings.
