Elma 3036 + 3038 + BM126 Page 48
WARNING
To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. The
meter is intended only for indoor use.
To avoid electrical shock hazard, observe the proper safety precautions when working with
voltages above 60 VDC or 30 VAC rms. These voltage levels pose a potential shock hazard to
the user.
Inspect test leads, connectors, and probes for damaged insulation or exposed metal before
using the instrument. If any defects are found, replace them immediately.
Do not touch test lead tips or the circuit being tested while power is applied to the circuit being
measured. To avoid accidentally short circuit of bare (uninsulated) hazardous live conductors or
busbars, switch them off before insertion and removal of the current clamp jaws. Contact with
the conductor could result in electric shock. Keep your hands/fingers behind the hand/finger
barriers that indicate the limits of safe access of the meter and the test leads during
measurement.
CAUTION
Disconnect the test leads from the test points before changing meter functions.
INTERNATIONAL ELECTRICAL SYMBOLS
!
Caution ! Refer to the explanation in this Manual
Caution ! Risk of electric shock
Earth (Ground)
Double Insulation or Reinforced insulation
Fuse
AC--Alternating Current
DC--Direct Current
2) Cenelec Directives
The instruments conform to CENELEC Low-voltage directive 73/23/EEC and Electromagnetic
compatibility directive 89/336/EEC
To Next Page
Loading...