elmeasure iACCL M Series User Manual

R
R
Y B
N
R
Y B
N
R
Y B
N
Display
Meaning Meaning
Display
Voltage line to line
Voltage YB Phase
Voltage line to Neutral
Voltage BR Phase
Current
Y phase
Voltage RY Phase
Was Total
B Phase
Total VA
Voltage
Power Factor
R phase
Frequency
4. Display of Parameter:
5. MECHANICAL SPECIFICATION:
a) iACCL M300, M330 (3 phase 40A Rating) & M100C ( 1 phase 40A Rating )
Surface Mounting Outer Dimension : 144 x 193 x 137mm
b) iACCL M300 & M330 ( 3 phase, 63A & 80A Rating ): Surface Mounting
Outer Dimension : 217 x 186 x 142mm
c) iACCL M300 & M330 ( 3 phase, 100A & 125A Rating ) : Surface Mounting
Outer Dimension : 310 x 240 x 182mm
iACCL M 300
119.7 mm
180.48 mm
4. WIRING DIAGRAM
RS 485
iACCL
EB Input
DG Input
Output
RS 485
iACCL
EB Input
DG Input
Output
a) EB 3 Phase & DG 3 Phase (M300)
b) EB 3 Phase & DG 1 Phase (M300 & M330)
R
N
+ -
+ -
198mm
163mm
5 mm
10 mm
218mm
285mm
10mm
5mm
Appropriate copper wire and lugs to be used. If lugs is not used, strands
can standout and short the terminal which will not be under warranty.
INPUT
P
N
P
N
OUTPUT LOAD
EB DG
N
Lights
Direct
M100C
c) EB 1 Phase & DG 1 Phase (M100C)
RS 485
+ -
CAUTION
During normal operation of this instrument, hazardous voltages are present at the
rear terminals, which may cause injury or death. Installation, disconnection or
removal of the meter should be carried out only by qualified, trained personnel,
after de-energizing connected circuit. The warranty will become void incase the seal
is broken, improper installation as well as improper grounding.
INFORMATION
Manufacturer assumes no responsibility for a hazard or damage caused by incorrect
or non-application of any of the instructions mentioned herein. ELMEASURE shall
not be liable for any consequential or resulting injury or for loss, damage or expense
directly or indirectly from the use of this product under any circumstances.
ELMEASURE does not claim any responsibility for the damage caused by using the
product directly or indirectly as sufficient care has been taken to provide all
information regarding the product. The user is advised to use according to the
operating instructions, professional practices, wiring rules, codes, safety regulations
applicable to the given installation.
R
Y B
N
RS 485
iACCL
EB
Input
DG
Input
+ -
Output
R
Y B
N
M300 M330
N
Note: DG Output available only in R Phase & Neutral
M330M300
M100C
5 mm
10mm

elmeasure iACCL M Series Specifications

General

Brand	elmeasure
Model	iACCL M Series
Category	Measuring Instruments
Language	English