WARNING: Before you begin installing the new MX-1 baseplate, make sure that your MX-1 unit is not
plugged into anything else, including the optional ELMO Connect Box.
Fold up the MX-1 unit and flip it over so that
the baseplate is facing upwards and the
serial numbers are visible.
Using a screwdriver, carefully remove the 2
screws from the bottom of the baseplate.
The baseplate is magnetized and will not
come off until manually removed.
Take off the baseplate and screws. Do not
throw away your baseplate – you may
need the serial number for later reference.
Place the new MX-1 baseplate on the
bottom of the unit, making sure that it is
properly aligned with the unit.
Replace the 2 screws and screw them back
into the bottom of the new baseplate to
finish installation.
To Next Page
Need help?
General
