Why does the LAN link LED not light up on Elmo Document Camera?
If the LAN link LED on your Elmo Document Camera does not light up, ensure that power is supplied to both the camera and the device connected to it. Check that the cable is firmly connected and then turn on the power. Also, verify the connection between the cable terminals and ensure that you are using the correct type of cable.
What to do if Elmo Document Camera image is too dark?
If the image from your Elmo Document Camera is too dark, the lighting intensity may be insufficient. Try turning on the LED lighting using the Brightness button on the operating panel, or adjust the Iris.
Why does Elmo Document Camera output image resolution change automatically?
If the output image resolution of your Elmo Document Camera changes automatically, it's likely because the resolution setting is set to Auto. Change the resolution setting to a fixed value.
How to fix out of focus image on Elmo Document Camera?
If the image from your Elmo Document Camera is out of focus, the document may be too close to the lens. Try moving the document slightly away from the lens.
What to do if the Elmo Document Camera recording stops?
If the recording on your Elmo Document Camera stops, especially when the resolution setting is set to Auto, it might be due to the HDMI cable being disconnected or the monitor being turned off during recording. Set the resolution setting to something other than Auto to continue the recording.
Why does Elmo Document Camera not operate with the remote control?
If you cannot operate your Elmo Document Camera with the remote control, the battery may be low. Replace it with a new one. Also, make sure you are using the remote control that was supplied with the camera.
Why some buttons on operating panel or remote control cannot be used in USB mode on Elmo Document Camera?
During UVC streaming, it is not possible to record camera images, display thumbnails, or playback still images or videos.
Why can't I connect to the PX-30E from the client?
If you cannot connect to the PX-30E from the client, designate the IP address set in the PX-30E. Ensure the network address is the same between the client and PX-30E.
How to troubleshoot no audio from external microphone on Elmo Document Camera?
If you're not getting any audio from the external microphone connected to your Elmo Document Camera, the audio volume might be too low. Go to the System Setting and adjust the volume. Also, check in the System Setting that 'External mic' is selected in the 'Sound switch'.
What to do if Elmo Document Camera image does not move?
If the image from your Elmo Document Camera is frozen, the 'Freeze' function may be activated. Press the Freeze button on the operating panel or remote control to restart the live image feed.
General| Brand | Elmo |
|---|---|
| Model | PX-30E |
| Category | Digital Presenters |
| Language | English |
To Next Page
