Why are images on SD card/USB flash drive not displayed on Elmo Document Camera?
If images on your SD card or USB flash drive are not displayed on your Elmo Document Camera, remove the SD card/USB flash drive, wait a few seconds, and then reinsert it.
How to fix the striped image on Elmo Document Camera?
If the image from your Elmo Document Camera appears striped, it may be due to interference fringes between the dots of printed matter and TV scanning lines or CMOS pixels. Changing the shooting range may improve the problem.
How to fix Elmo Document Camera when no image is displayed from the USB port?
If no image is displayed from the USB port on your Elmo Document Camera, check the USB mode in the System Setting. If it's set to 'Mass storage (file transfer)', select 'UVC (image output)' instead.
Why does Elmo Document Camera not operate with the remote control?
If you cannot operate your Elmo Document Camera with the remote control, the battery may be low. Replace it with a new one. Also, make sure you are using the remote control that was supplied with the camera.
What to do if the Elmo Document Camera recording stops?
If the recording on your Elmo Document Camera stops, especially when the resolution setting is set to Auto, it might be due to the HDMI cable being disconnected or the monitor being turned off during recording. Set the resolution setting to something other than Auto to continue the recording.
How to fix out of focus image on Elmo Document Camera?
If the image from your Elmo Document Camera is out of focus, the document may be too close to the lens. Try moving the document slightly away from the lens.
Why does Elmo Document Camera output image resolution change automatically?
If the output image resolution of your Elmo Document Camera changes automatically, it's likely because the resolution setting is set to Auto. Change the resolution setting to a fixed value.
What to do if Elmo Document Camera image is too dark?
If the image from your Elmo Document Camera is too dark, the lighting intensity may be insufficient. Try turning on the LED lighting using the Brightness button on the operating panel, or adjust the Iris.
General| Brand | Elmo |
|---|---|
| Model | PX-30E |
| Category | Digital Presenters |
| Language | English |
To Next Page
