46
➌ -8 USING WOL [WAKE ON LAN] FEATURE (FOR
PX-30E ONLY)
By connecting the PX-30E and your PC in the same network using the LAN cable, you can turn on
the PX-30E remotely from your PC while the PX-30E is turned off.
You can save time by turning on the PX-30E remotely from your PC before you go to the place
where the PX-30E is installed.
Before using WOL, verify the following:
- The PX-30E and your PC are connected to the same network via the LAN cable.
- A communication software which can send WOL commands is installed in your PC.
- The PX-30E is connected to a power source using the AC adapter and AC power cord.
- When the PX-30E was turned off last time, the WOL setting was ON and the PX-30E was turned
off either by the Power button or by the remote control or by RS-232C or by network commands.
<How to start the PX-30E using WOL>
1. Start a communication software which can send WOL commands.
2. Enter information such as MAC address to the software. Send commands to start the PX-30E.
3. After receiving the commands, the PX-30E will turn on.
➌ -9 USING IN MASS STORAGE MODE
The PX-10E/30E will be recognized as a removable disk when it is connected to a PC via the USB
cable in Mass storage mode.
You can view files stored in the PX-10E/30E from a PC using a viewer or transfer them to a PC.
<How to set Mass storage mode>
1. Set the USB mode to “Mass storage” from the System Setting menu. (⇒P.28)
2. Connect the PX-10E/30E and your PC using the USB cable.
3. Files will be displayed automatically on the PC.
4. Open the folder and you will see a list of still images or videos.
<How to cancel Mass storage mode>
1. Disconnect the USB cable from the PX-10E/30E.
2. The USB mode will be changed to the UVC mode from the Mass storage mode.
CAUTION
If the PX-10E/30E is turned off while the Auto lock is ON, the PX-10E/30E will start with the Auto lock
ON the next time it is turned on. The Auto lock will be activated if no operation of buttons on the
operating panel or the LCD touchscreen continues for 30 seconds.
CAUTION
・For details of the communication software, refer to the instruction manual of the communication
software.
・It is recommended to set the Auto wake up function to ON when you set the WOL setting to ON.
CAUTION
・It is not possible to operate the PX-10E/30E during Mass storage mode.
・It is not possible to save, delete or format the file from a PC.
To Next Page
Loading...
