Elmo PX-30E - ➍ Error Messages

49
➍ ERROR MESSAGES
Error message
Possible cause/Countermeasure
SD card is not ready.
The PX-10E/30E failed to start the video recording.
Check the followings:（⇒P.15、34）
・The SD card is not inserted into the SD card slot.
・The SD card is broken.
・The remaining capacity of the SD card is insufficient
・The SD card is not formatted.（⇒P.29）
・The SD card was removed during data saving.
SD card is full. Recording is
stopped.
The video recording stopped because there is insufficient free
space on the SD card. (A video recording file up to the point the
recording is stopped will be created.)
Replace the SD card or delete unnecessary files.（⇒P.39）
SD card/USB flash drive is not
ready.
The PX-10E/30E failed to capture a still image.
Check the followings:
・The SD card/USB flash drive is broken.
・The remaining capacity of the SD card/USB flash drive is
insufficient.
・The SD card/USB flash drive is not formatted.（⇒P.29）
・The SD card/USB flash drive was removed during data saving.
Displaying RGB input
When outputting the image being input to the RGB in port to an
external monitor, no image is displayed on the LCD touchscreen.
（⇒P.26）
Cannot display images
This message appears when HDCP-protected signals is input to
the PX-10E/30E after selecting the HDMI in the Select image
menu.
（⇒P.26）
To display images on the LCD touchscreen, input unencrypted
HDMI signals.
Failed to delete file.
The PX-10E/30E failed to delete the file.
The thumbnail list screen will be displayed in 2 seconds after this
message. Try again from the beginning.
Failed to format.
The PX-10E/30E failed to format the SD card/USB flash drive.
Try again from the beginning.