ELNA eXplore 220 - Inserting the Bobbin Correctly

28
Inserting the Bobbin
1. Place the bobbin in the bobbin case. Make sure
the thread unwinds in the direction shown in the
illustration.
2. Pull the thread into the bobbin case slot.
3. Draw the thread under the tension spring and
into the delivery eye.
Pull out about 15 cm (6”) of thread.
4. Pull out the latch on the bobbin case.
Insert bobbin case. Make sure the prong fits into
the hook race.
Close bobbin cover.
1
2
3
4