Why ELNA Sewing Machine won't sew with the start/stop button?
The machine won’t sew with the start/stop button if the foot control is connected. Disconnect the foot control to use the start/stop button.
What to do if the bobbin winder spindle is shifted to the right on my ELNA Lotus Sewing Machine?
If the bobbin winder spindle is shifted to the right, push it to the left.
Why does the needle thread keep breaking on my ELNA Sewing Machine?
The needle thread may break due to several reasons: * The needle thread is not threaded properly. * The needle thread tension is too tight. * The needle is bent or blunt. * The needle is incorrectly inserted. * The needle thread and the bobbin thread are not set under the presser foot when starting to sew. * The threads were not drawn to the rear after sewing. * The thread is either too heavy or too fine for the needle.
Why does the bobbin thread break on my ELNA Lotus?
The bobbin thread may break because: * The bobbin thread is not threaded properly in the bobbin holder. * Lint has collected in the bobbin holder. * The bobbin is damaged and doesn’t turn smoothly. If this is the case, replace the bobbin. * The thread is wound loosely on a bobbin.
Why is my ELNA Sewing Machine seam puckering?
Seam puckering can occur on your ELNA Sewing Machine if: * The needle thread tension is too tight. * The needle thread is not threaded properly. * The needle is too heavy for the fabric being sewn. * The stitch length is too long for the fabric. If this happens, make the stitches shorter.
Why is my ELNA Lotus not running smoothly and is noisy?
Your ELNA Sewing Machine may not run smoothly and be noisy if: * Thread has been caught in the hook race. * Lint has built up in the hook race or bobbin holder.
What to do if the ELNA Sewing Machine automatic thread cutter fails?
If the automatic thread cutter fails due to tangled thread in the hook area or electronic component failure, first remove any tangled threads from the hook area. If the error persists after cleaning the hook area, contact customer service or the dealer from whom the machine was purchased.
What to do if my ELNA Lotus Sewing Machine was stopped due to overload?
If your machine stopped due to an overload, wait at least 15 minutes before restarting it. Also, remove any jammed threads.
Why does my ELNA Lotus not work?
Your ELNA Sewing Machine may not work due to: * The machine not being plugged in. * Thread having been caught in the hook race. * The bobbin winder spindle not being returned to the left after bobbin winding.
What to do if a buttonhole was sewn without lowering the buttonhole lever on my ELNA Lotus?
If a buttonhole was sewn without lowering the buttonhole lever, lower the buttonhole lever and restart the machine.
General| Brand | ELNA |
|---|---|
| Model | Lotus |
| Category | Sewing Machine |
| Language | English |
To Next Page
