ELNA PRO 704 DEX - Instant Rolled;Narrow Hem Device; Upper Looper Release Lever; 2 Thread Converter Operations; Overlock Cover Removal

\I xu] ©
OPERATION PROCEDURE
BY SECTIONS
Following the Screen Instructions
©) Instant Rolled/Narrow Hem Device
(Stitch Width Finger)
To disengage the lever, as per the program display screen,
pull the knob to the right and swing the lever down. To
engage it, proceed in the same manner.
© Upper Looper Release Lever
Make sure that the needle bar is at the lowest position.
To disengage the looper, as per the program display
screen, push the lever down and shift it to the left. To
engage the looper, proceed in the same manner,
@ Attaching the 2 Thread Converter
Depending on the program display screen, engage the
hook to the upper point of the looper and fit it to the
looper base.
(8) Removing the 2 Thread Converter
To disengage, proceed in the same manner as above.
@) Removing the Overlock Cover
To remove the overlock cover, as per the program display
screen, open the front door and remove the cover,
as shown. Make sure that the upper looper is disengaged
and the moving blade lowered.
Installing the Sewing Table
Attach the sewing table and close the front door,
as shown.