IDS Touchmonitor Connections to an External Computer
1. Connect the included HDMI cable (or your own VGA or DisplayPort cable) between the
monitor and the video source.
2. Connect the USB touch cable between the monitor and your host PC.
3. Select the correct power cable for your region. Connect it between the AC power source
and the touchmonitors POWER IN connector.
4. The touchmonitor ships in an ON state.
a. In order to access the OSD menu, press the Menu button located on the bottom
right side on the back of the monitor.
Installing the IDS Touchscreen Technology Software Drivers
Visit the Elo Touch Solutions website www.elotouch.com for:
• Updates to the Elo touch driver
• Additional touch driver information
• Detailed touch driver installation guides
• Touch drivers for other operating systems
IDS02 series monitors are HID compatible, but will require the Elo driver if Windows 8 or higher
Charm bars are to be accessed.
TouchPro and Infrared units are HID compatible and do not require an Elo touch driver. If an Elo
touch driver has previously been installed on the host computer, remove this driver by opening
Control Panel and selecting the option to remove the driver completely.
To Next Page
Loading...
