eg, “*# 20060123 20060346 20060222 *"
Last one will be any adapter USB-MSP430-FPA or MSP-FET430UIF not listed before.
List of the acceptable numbers or IDs for the MSP-FET430UIF adapter:
When the MSP-FET430UIF adapter is used, then fro compatibility with the USB-MSP430-
FPA adapters software is assigning the serial number for these adapters. Serial number for
these adapters is created with following formula
SN = 20010000 + 200 * HID + 100 * COM + port_number
For example if adapter is using COM port # 6 then the eq. serial number is calculated as
SN = 20010000 + 200 * 0 + 100 * 1 + 6 = 20010106
Assigned serial number allows to use application software without modification for the USB-
MSP430-FPA and MSP-FET430UIF adapters. No modification of the application software
is required. However, for simplicity the current API-DLL software can accept also other,
more convenient definition for the MSP-FET430UIF adapters .
1. FPAs serial number - 8 digits eg. 20010106
eg, “*# 20060123 20060346 20060222 20010106"
Four USB-MSP430-FPA will be used with SN as listed above
FPA-1 20060123 - USB-MSP430-FPA
FPA-2 20060346 - USB-MSP430-FPA
FPA-3 20060222 - USB-MSP430-FPA
FPA-4 20010106 - MSP-FET430UIF
2. ID UIF - to select any MSP-FET430UIF only. No UIF’s serial number can be
specified after this definition.
eg, “*# 20060123 20060346 20060222 UIF"
Last one will be an any adapter MSP-FET430UIF.
eg, “*# UIF"
The MSP-FET430UIF adapter only.
3. ID ‘*’ - to select any adapter - USB-MSP430-FPA or MSP-FET430UIF. No other
adapters can be specified after this definition.
eg, “*# 20060123 20060346 20060222 *"
Last one will be any adapter USB-MSP430-FPA or MSP-FET430UIF not listed before.
Note: If it is used one any MSP-FET430UIF adapter, then it is recommended to use definition “*# UIF"
instead “*# *". With the first definition software will search only the MSP-FET430UIF adapter. With
the second definition software will search the USB-MSP430-FPA adapter first, and if this adapter is
40
To Next Page
Loading...