be calibrated using the FlashPro430 GUI package software when the JTAG or Spy-
Bi-Wire access is available (when the JTAG fuse is not blown). See the FlashPro430
manual for details.
* All MAIN memory is tested in the same way as it is used with the JTAG/Spy-Bi-
Wire interface
* Word write/read to TACCR0 (0x172) register.
* Access to RAM if size of the RAM if higher then 256 bytes. Access to RAM space
0x200 to 0x2FF is blocked due to stack and firmware located in this RAM location.
Note: The first test (Vcc value when the power is OFF) can be failed, if the external power is
connected or if the blocking capacitor on your target device connected to the Vcc line if high.
The Vcc should be below 0.4V when the power is OFF, tested 2 seconds after switching-off
the power from FPA, otherwise test failed.
The Self Test programming software package is located in directory
C:\Program Files\Elprotronic\MSP430\USB FlashPro430\SelfTest
or
C:\Program Files\Elprotronic\MSP430\FET-Pro430\SelfTest
and contains following files
MSP430FPA.dll - Multi-FPA selection/distribution DLL
MSP430FPA1.dll - USB-FPA DLL
MSPFET430UIF1.dll - DLL fro TI’s MSP-FET430UIF
config.ini - default configuration file for the FPAs
FlashPro430SelfTest.exe - executable file
To run the executable file FlashPro430SelfTest.exe it in the other location the files listed above
should be copied “as is” to destination directory.
2.2 MyMSP430Prg Projects
The MyMSP430Prg projects are examples of using the Multi-FPA API-DLL with Microsoft Visual
Studio 7.0 (2002) and for Microsoft Visual Basic 6.0. They are intended to help users create their
own application that uses the API-DLL by providing a simple starting point. When using Visual
Studio C++ include the following files should be included to your program:
MSP430FPA.lib
MSPPrg-Dll.h
MspFPA-Lib.h
19
To Next Page
Loading...