Need help?Do you have a question about the Elster 6 Series and is the answer not in the manual?
General| Brand | Elster |
|---|---|
| Model | 6 Series |
| Category | Measuring Instruments |
| Language | English |
Explains the manual's purpose, scope, and compliance with directives and standards.
Outlines warranty provisions and manufacturer's responsibility for product use and potential damages.
Explains formats for hazard warnings, safety instructions, and tips for clear communication.
Details various character formats used in the manual, including hyperlinks and special symbols.
Lists and defines abbreviations used throughout the document for clarity and consistency.
Provides an overview of the UFM Series 6 Q.Sonicplus, its design, and capabilities.
Lists the European directives and international standards the flow meter complies with.
Describes the path types (Axial and Swirl) and the Q.Sonicplus path layout.
Explains the requirement for calibration in custody transfer applications and lists calibration facilities.
Explains how ultrasonic pulses are used to measure gas velocity based on travel times.
Details how the meter is adjusted after calibration, either by factor or linearization.
Describes the calculation of volume flow using gas velocity and flow cell cross-section.
Describes the flow cell, SPU, and transducers as key components of the meter system.
Details optional sensors, labels, and nameplates, including certification information like ATEX, IECEx, FM, CSA.
Outlines important sealing locations and processes as required by MID certificate and general advice.
Covers initial checks, pipeline installation, and testing requirements for the flow meter.
Details wiring instructions, SPU configuration, and procedures for cold and hot commissioning.
Explains the function of the two LEDs (Power and Status) for meter indication.
Describes the interactive touch screen display and its 7 touch areas for measurements and diagnostics.
Details the values displayed on the basic screen, including Qline, Vm FWD, Vm REV, and Vline.
Shows the Home Screen menu with options like Language Selection, Info, Error List, and System.
Explains how to access and interpret general meter diagnostics and path-specific data.
Describes how to access general information about electronics and software, including submenus.
Covers data collection methods and rules for analysing measured data like sample rate and performance.
Details procedures for exchanging parts like sensors, transducers, and SPU, including warnings and precautions.
Explains how to check software versions and checksums of various meter components.
Guides on checking the software status of different modules via the front panel.
Describes how to perform a display test to check screen functionality.
Explains how to view and accept meter errors and warnings via the front panel.
Introduces the SonicExplorer software for configuration and monitoring, with download information.
Details the available user profiles (Admin, User1, User2) and their respective permissions.
Provides guidelines for careful handling and proper storage conditions to maintain instrument integrity and warranty.
Explains the applicability of MID requirements for fiscal metering and environmental class compliance.
Lists the applicable directives (PED, ATEX, EMC, MID) the meter complies with.
Mentions the requirement for sealing MID compliant meters and refers to relevant sections.
Describes the documentation accompanying an MID compliant meter for calibration and conformity.
Highlights special attention needed for mounting according to EC certificate and power supply requirements.
To Next Page
